Grab Rails / August 5, 2018 / MillicentChaloux
If proper steps like those mentioned above are not taken serious injury can occur if the grab bar would pull out f the wall unexpectedly when pressure is applied. Grab Bar Location Another Senior Safety tip for effectively and safely installing grab bars involves the placement of grab bars. Good placement of grab bars and safety handrails is anywhere you need to change your elevation slowly steadily and under control. If the grab bar will be used when seated mount the bar on a slant starting low and close to toilet or other seated location at a maximum of 24" above the finished flooring. The bar should be slanting upward toward the direction of egress. This will ensure that the person using the bar for support can reach it comfortably and get the most help possible from the grab bar.
Grabbing onto the bars helps people who have limited mobile abilities maintain their balance. Individuals with disabilities will require grab bars to be installed in their homes especially if they do not have someone to care for them throughout the day. The chances of falling or slipping while in the bathroom are always relatively high even with individuals who do not have limited mobile abilities. In the bathroom there is a lot of water supply. Each time someone washes their hands or takes a shower they might accidentally leave a few small puddles of water on the tile ultimately creating a hazard for anyone who enters.
Some safety bars are fold away in function particularly ones meant for use around toilets which then gives the option for either use depending upon who needs the bar or not and there are smaller more temporary installations that clamp on the side of a bathtub to assist with getting in and out. The most important rule to follow in a permanent installation is that any safety grab bar must be attached to a wood wall stud or a pre-placed interior wall block 2 x 6 or 8. Common wall anchors or molly bolts are not acceptable and could just be a problem and or worse yet an injury later. After saying all that I know there is a wall anchor out there that meets mounting standards and is called Toggler I have personally never used any of these but they are supposed to be acceptable for mounting grab bars when no stud in the wall is available in the position needed.